2023/07/14
Maintenance and maintenance of bearings in the organic fertilizer chain crusher: for the organic fertilizer crusher, the bearing bears the full load of the equipment, so its quality is good or bad, and whether the changing state is good or not, will be related to the service life of the bearing, and then affect the service life of the chain crusher equipment, so attention should be paid to it. Here Tenke mechanical organic fertilizer crusher manufacturers remind you:
1, in the use of lubricating oil, its main requirements are: the lubricating oil used must be clean and good quality, if the quality is not qualified, or there are impurities in it, it is determined not to be used.
2, the lubrication part of the grinder bearing, in general, there are rotating bearings, roll bearings, active bearings, gear and sliding plane, if this is for these, indispensable.
3, before the trial operation should be rigorously checked whether the installation of all parts of the equipment is in accordance with the regulations, the screw anchor bolt is not loose, the drive belt can be gently pulled by hand, whether there is a situation such as touching the shell. Other check the rotation orientation to prevent the breaking of flammable and explosive parts to prevent safety accidents.
4, production should adhere to the symmetrical opening to ensure the quality of crushing and all normal production, other to prevent the motor load to ensure the normal operation of organic fertilizer equipment.
5, in addition to often careful to check the tightening loose, other more should be careful to check the damage of spare parts, such as serious damage should be replaced immediately to prevent the destruction of key components. And choose relative fire safety countermeasures.
7, due to the relatively high speed, in addition to the installation of reasonable consolidation, other should adhere to stable lubrication, in order to adhere to the normal operation of all the tree crusher. Under normal conditions, the bearing temperature does not exceed 70 degrees. The main engine bearing is added with butter once a week, and the actual effect of high-speed butter is stronger.
